Input Voltage rating (standard) 85-264 Vac or 90-300 Vdc

Input Voltage rating (low voltage option) 12-32   Vac or 10-48 Vdc

Power Line Frequency DC and 47-63 Hz

Power Consumption, Max 5 Watts

Recommended Load 350-10K ohm bridge

Voltage & Current Levels (jumper selectable) 5 Vdc ±5%,   100 mA max

10 Vdc ±5%, 120 mA max

24 Vdc ± 5%, 40 mA max

Excitation Output Ripple 100 mVp max

Isolation from power and outputs 250 Vac

Insulation dielectric strength to power and outputs 3.5 kV ac   for 5 sec, 2.3 kV ac for 1 min

Isolation to signal common 50 Vdc

Power to Relay Option Powered by meter

Setpoint Setup Via front panel pushbuttons or RS232/485

Update Rate 56/s at 60 Hz, 47/s at 50 Hz

Response to input signal (min) Display update rate

Input Signal (selectable) Filtered or unfiltered input signal

Actuation Modes (selectable) Above or below setpoint, latching   or non-latching, disabled

Output Time Delay (selectable) 1 to 128 readings

Front Panel Enable / Lockout Modes (selectable) 1) Display and   change setpoints

2) Display but do not change setpoints

3) Neither display nor change setpoints

Alarm Status Indication 2 or 4 red LED lamps

Status Indication Setup (selectable) Lit when output is ON or   OFF, or disabled

Form C, SPDT Relay Output:

AC Rating 8A @ 240 Vac

DC Rating 8A @ 24 Vdc

Isolation rating between signal common and contacts 250 Vac

Insulation dielectric strength between signal common and   contacts

3.5 kV ac for 5 sec, 2.3 kV ac for 1 min

Form A, SPST Solid State Relay Output:

AC Rating 120 mA @ 140 Vac

DC Rating 120 mA @ 180 Vdc

Isolation rating between signal common and contacts 250V ac

Insulation dielectric strength between signal common and   contacts

3.5 kV ac for 5 sec, 2.3 kV ac for 1 min

Power to Analog Output Option Powered by meter

Output Levels 0-20 mA, 4-20 mA, 0-10V, -10   to +10V

Voltage Compliance, 0-20 mA Output 12V (0-600 Ohm load)

Current Compliance, 0-10V, -10 to +10V Output 2 mA (5 kOhm or   higher load)

Accuracy Meter input accuracy ±0.02% of full scale analog   output

Resolution 16 bit (1 part in 65,536)

Response Time 50/60Hz update rate

Scaling of Reading for Zero Output -99,999 to +99,999

Scaling of Reading for Full Scale Output -99,999 to +99,999

Isolation rating between signal common and analog output 250V   ac

Insulation dielectric strength between signal common and   analog output

3.5 kV ac for 5 sec, 2.3 kV ac for 1 min

Control Inputs (CMOS/TTL levels, logic 0 = tied to digital   ground, logic 1 = open)